Once stopped, visually check the state of your tyres, if one of them is entirely flat, change your wheel, if it is only under-inflated, go carefully to a petrol station. Check the tire pressure of your Volvo XC60 using the pressure gauge and follow the brand suggestions on a label in the driver’s door. If you perceive during this re-inflation Scroll down and select TIRE MONITOR. Use the navigation button to scroll. Press and hold the OK button until a confirmation message appear on the screen. Done! Not all vehicle models are equipped with this menu. Please contact the authorized dealer to reset TPMS if you cannot use the method above. TPMS Reset: Ford Expedition Tire Pressure Sensor Light (2008-2020) – The Ford Expedition is a large upper mid-range off-road vehicle sold from 1997 to the present. The model of the American manufacturer Ford is only produced and sold in North America. The third generation sold from 2007. This generation is available with a 5.4-liter V8 engine. 1. Inflate all tires to pressure listed on vehicle placard. 2. Leave the driver’s door open during the relearn procedure. 3. Turn ignition to OFF position and press and release brake pedal. 4. Cycle ignition from the OFF to RUN position 3 times, ending in the RUN position. 5. 225 55 R16 99W XL. 38. 38. Ford S-Max 2.0. 235 45 R18 98W XL. 38. 38. Note: This advice is provided for informational purposes and is only to be used as a guide. Consult your owner’s manual for specific tyre (tire) pressure values for Ford S-Max. How to reset the service light / Oil change required on 2017 Ford B Max Check Euro car parts - For push-button ignitions, press the START/STOP button once while not touching either of the pedals. Within a 10-second window, turn your Ford’s hazards lights on and then off three times. If you do it correctly, the horn will sound. Activate the TPMS sensor by removing the valve cap on the tire. 8) Push the ignition button three times (once per second). The vehicle should be OFF. 9) Push the ignition button twice (once per second). The vehicle should be in RUN mode, engine off. 10) The horn should sound letting you know the vehicle has entered into TPMS relearn mode. Hi, this morning I got in my car and I got a 'check tyre pressure' message on screen. I've tried looking through manual but couldn't find much and was in a rush to get to work - could anyone please let me know the correct tyre pressure for both front and rear tyres on a Ford Fiesta Zetec S 1.0 Ecoboost - 2015 plate. 2. Place the ignition in the off position and keep the key in the ignition. 3. Cycle the ignition to the on position with the engine off. 4. Turn the hazard flashers on then off three times. You must accomplish this within 10 seconds. If the reset mode has been entered successfully, the horn. VP5fpU.